Difference between revisions of "VTube-LASER v2.9.14"
(→25pxFIXED - REPAIRED A BUG in CUT PLANE STORAGE)) |
(→25pxFIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST)) |
||
| Line 94: | Line 94: | ||
<td width=300> | <td width=300> | ||
| − | We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will | + | We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.)<br><br> |
| − | This has been fixed. | + | This has been fixed so that cleared Cut Planes never reappear. |
</td> | </td> | ||
Revision as of 20:24, 28 August 2018
|
Revision 2.9.14Release Date: In development
|
|
Contents |
NEW - ENTER FRACTION VALUES for FLOATING POINT in PART SETUP, XYZ GRIDS, and LRA GRIDS
|
We discovered a customer that had to manually convert Imperial fractional units from a tube print. So we taught VTube how to accept fraction values in the PART SETUP, XYZ GRIDS, and LRA GRIDS. Acceptable Fraction Forms
Rule Breaker Examples
|
|
NEW - VTUBE IS NOW COMPATIBLE WITH THE NEW FARO 8-AXIS USB DRIVER (6.2.0.26)
|
Previous versions of VTube-LASER will not read the ball probe values with this new driver. |
|
FIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST)
|
We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.) |
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
