Difference between revisions of "VTube-LASER v2.9.15"
(→25pxNEW - ENTER FRACTION VALUES for FLOATING POINT in PART SETUP, XYZ GRIDS, and LRA GRIDS) |
(→25pxFIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS) |
||
Line 58: | Line 58: | ||
<td> | <td> | ||
− | [[image:vtl_v2.9. | + | [[image:vtl_v2.9.15_splitbend_import.png|400px]] |
</td> | </td> | ||
Revision as of 21:59, 8 October 2018
Revision 2.9.15Release Date: October 8, 2018
|
NEW - END LENGTH FILTER - SHIFTS LENGTH CORRECTIONS BETWEEN A-END and B-END
FIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS
If you import models with 180-degree bends, then you will use the Split Bend collection feature in VTube-STEP and the Split Bend measure feature in VTube-LASER. |
FIXED - CLEARING ALL CUT PLANES from the CUT PLANE LIST NOW WORKS
We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.) |
NEW - REPORT ABSOLUTE CONRAC CORRECTIONS
NEW - RONIKolli7 Bender Simulator ASCII XYZ File Import
OTHER CHANGES
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature