Difference between revisions of "VTube-LASER v2.9.15"
(→25pxFIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS) |
(→25pxFIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS) |
||
| Line 52: | Line 52: | ||
<td width=300> | <td width=300> | ||
| − | If you import models with 180-degree bends, then you will use the Split Bend | + | If you import models with 180-degree bends, then you will use the Split Bend COLLECTION feature in VTube-STEP. If you measure 180-degree bends, then you will use the Split Bend MEASURE feature in VTube-LASER.<br><br>Both of these features use the same Split Bend math logic.<br><br> |
In that case, this is a critical update for you that addresses an issue we discovered during some research into Split Bend measuring issues with a customer. The problem we found could cause the centerline of the Split Bend construction to be short by 0.020 inches (0.5 mm).<br><br> | In that case, this is a critical update for you that addresses an issue we discovered during some research into Split Bend measuring issues with a customer. The problem we found could cause the centerline of the Split Bend construction to be short by 0.020 inches (0.5 mm).<br><br> | ||
If you use Split Bend to import solid models or measure 180-degree bends, then this update is critical for you. | If you use Split Bend to import solid models or measure 180-degree bends, then this update is critical for you. | ||
Revision as of 22:01, 8 October 2018
|
Revision 2.9.15Release Date: October 8, 2018
|
|
NEW - END LENGTH FILTER - SHIFTS LENGTH CORRECTIONS BETWEEN A-END and B-END
|
|
|
FIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS
|
If you import models with 180-degree bends, then you will use the Split Bend COLLECTION feature in VTube-STEP. If you measure 180-degree bends, then you will use the Split Bend MEASURE feature in VTube-LASER. |
|
FIXED - CLEARING ALL CUT PLANES from the CUT PLANE LIST NOW WORKS
|
We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.) |
|
NEW - REPORT ABSOLUTE CONRAC CORRECTIONS
|
VTube-LASER can now report absolute CONRAC bender corrections using new HTML report template values.
|
|
NEW - RONIKolli7 Bender Simulator ASCII XYZ File Import
|
|
|
OTHER CHANGES
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
