Difference between revisions of "VTube-STEP v2.9.18"
From ATTWiki
(→25pxNEW - Selection Inversion Added) |
(→25pxNEW - Selection Inversion Method Helps Select Parts in an Assembly) |
||
| (One intermediate revision by one user not shown) | |||
| Line 24: | Line 24: | ||
| − | ==[[image:Check.jpg|25px]]NEW - Selection Inversion Method Helps Select Parts== | + | ==[[image:Check.jpg|25px]]NEW - Selection Inversion Method Helps Select Parts in an Assembly== |
<table cellpadding=10 width=1400> | <table cellpadding=10 width=1400> | ||
| Line 31: | Line 31: | ||
<td width=300> | <td width=300> | ||
Selection inversion makes selecting parts from inside an assembly much easier.<br><br> | Selection inversion makes selecting parts from inside an assembly much easier.<br><br> | ||
| − | See the slides on the right to see how selection inversion is used. | + | See the slides on the right to see how selection inversion is used.<br><br> |
| + | [[image:vts_2.9.18_selectioninversion_menu.png|300px]] | ||
</td> | </td> | ||
Latest revision as of 20:37, 13 March 2019
|
Version 2.9.18Release Date: March 12, 2019
|
|
Contents |
NEW - Selection Inversion Method Helps Select Parts in an Assembly
|
Selection inversion makes selecting parts from inside an assembly much easier. |
|
NEW - OMCG SVNET Communications Protocol
|
This protocol allows you to correct OMCG benders. |
|
NEW - Now VTube has THREE Default Radii
| Radius 1, Radius 2, and Radius 3 are now available in Part Setup. |
|
Other Changes
- NEW - Autobuild Parametrics now calculates the CUT LENGTH automatically in VTube-STEP.
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See Customer Support Page to download the latest version.
