Difference between revisions of "Multi-Elongation in VTube"
From ATTWiki
(→Multi-Elongation Percentage Compensation Setup) |
(→Read More About Tube Elongation) |
||
| Line 27: | Line 27: | ||
==Read More About Tube Elongation== | ==Read More About Tube Elongation== | ||
| − | * About [[Tube Elongation Percentage | + | * About [[Tube Elongation Percentage]] |
* [[How to Calculate Tube Elongation Percentage in VTube-LASER]] | * [[How to Calculate Tube Elongation Percentage in VTube-LASER]] | ||
Latest revision as of 16:11, 1 June 2016
|
|
|
Multi-Elongation Percentage Compensation Setup
VTube allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS
Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.
A new checkbox is added at the bottom of Part Setup to allow this feature to be activated.
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
