Difference between revisions of "VTube-LASER v2.8.4"
(→25px IMPROVED: REVERSE CALC) |
(→25px NEW DATUM REPORTS POSSIBLE) |
||
| Line 56: | Line 56: | ||
| − | ==[[image:Check.jpg|25px]] NEW DATUM | + | ==[[image:Check.jpg|25px]] NEW DATUM REPORT TEMPLATES - MEASURED Distances to MASTER DATUM== |
<table cellpadding=10 width=900> | <table cellpadding=10 width=900> | ||
| Line 74: | Line 74: | ||
<td> | <td> | ||
| − | [[image:vtube-laser_2.9. | + | [[image:vtube-laser_2.9.4_datum_report.png|400px]] |
</td> | </td> | ||
<td> | <td> | ||
Revision as of 00:03, 23 June 2017
|
Revision 2.8.4Original Release Date: June 22, 2017
|
|
Contents |
NEW: MULTISCREEN "SWITCH SCREEN" BUTTONS
|
When multiple screens are present, then VTube now adds "SWITCH SCREEN" buttons in the toolbars. |
|
IMPROVED: REVERSE CALC
|
In previous versions, when performing REVERSE CALC from bender data to centerline XYZ data, VTube-LASER could not keep the previous part orientation in 3D space when the first leg ran parallel to the Z axis. |
|
NEW DATUM REPORT TEMPLATES - MEASURED Distances to MASTER DATUM
|
Now VTube-LASER can show DATUM reports with Measured-aligned distances to MASTER Datums.
|
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
