Difference between revisions of "VTube-LASER v2.9.2"
From ATTWiki
(→25pxFIXED and IMPROVED - Bend Profile) |
(→25pxFIXED and IMPROVED - Bend Profile Calculations) |
||
| Line 50: | Line 50: | ||
<td width=300> | <td width=300> | ||
The same issues that affected the Split Bend logic also affected the Bend Profile logic.<br><br>This has been repaired in this version. | The same issues that affected the Split Bend logic also affected the Bend Profile logic.<br><br>This has been repaired in this version. | ||
| + | </td> | ||
| + | |||
| + | <td> | ||
| + | [[image:bendprofile.png|500px]]<br><br> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | <br><br> | ||
| + | |||
| + | |||
| + | |||
| + | ==[[image:Check.jpg|25px]]Other== | ||
| + | |||
| + | <table cellpadding=10 width=800> | ||
| + | <tr valign=top> | ||
| + | |||
| + | <td width=300> | ||
| + | * You can now change items inside the System Options window and immediately save them as part of the default project setup inside System Option. (In previous versions, it was necessary to exit System Options then re-enter before saving the default project.) | ||
</td> | </td> | ||
Revision as of 21:58, 1 December 2017
|
Revision 2.9.2 Build 104Release Date: December 1, 2017
|
|
FIXED and IMPROVED - Split Bend - Finding Surface Edges
|
As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends. |
|
FIXED and IMPROVED - Bend Profile Calculations
|
The same issues that affected the Split Bend logic also affected the Bend Profile logic. |
|
Other
|
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
