Difference between revisions of "Cable Spec 2"

From ATTWiki
Jump to: navigation, search
(Label)
(Label)
Line 93: Line 93:
  
 
==Label==
 
==Label==
<font size=3>It is important to label these adapters with "CO", which means "Crossover" - so that they are not mixed up with the ST adapter (cable spec 1).</font>
+
<font size=4><b>It is important to label these adapters with "CO", which means "Crossover" - so that they are not mixed up with the ST adapter (cable spec 1).</b></font>
  
 
==Important Testing Note==
 
==Important Testing Note==

Revision as of 16:48, 9 December 2017

I2t adapter.jpg

Contents

Spec for RJ-45 to DB-9 Female Adapter - "CO" or Crossover


This is the original RJ-45 to DB-9 conversion spec for the crossover. It is good for all applications except Benderlink Ethernet Modules with the CB-EL1 current loop board.

Use DB-9 female for connection to standard male COM ports.

Combine this adapter with Cable Spec 1 adapter to create a crossover cable good for connecting two RS-232 ports for communications.

Function Wire
Color
RJ-45
Pin
to DB9
Pin
Function
RTS Blue 1 ---- 8 CTS
DTR Orange 2 ---- 6 DSR
GND Black 3 ---- 5 GND
TXD Red 4 ---- 2 RXD
RXD Green 5 ---- 3 TXD
DCD Yellow 6 ---- none none
DSR Brown 7 ---- 4 DTR
CTS Grey 8 ---- 7 RTS


Label

It is important to label these adapters with "CO", which means "Crossover" - so that they are not mixed up with the ST adapter (cable spec 1).

Important Testing Note

The receiving pins in this adapter are prone to jump out of their inserted holes if they are not properly pressed in.

With the plug NOT snapped into the cover, plug the port into a DB9 male port to be sure none of the receiving pins are pressed back out of the inserted holes.



Other Pages