Difference between revisions of "VTube-LASER v2.9.5"
(→25pxNEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS) |
(→25pxNEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS) |
||
| Line 87: | Line 87: | ||
<td width=400> | <td width=400> | ||
When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc.<br><br> | When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc.<br><br> | ||
| − | If you exit the grid, then it will immediately ask | + | If you exit the grid without a reverse calc, then it will immediately ask if you intended to perform a Reverse Calc - and allow you to choose to calculate the XYZ data.<br><br> |
This is active in both the MASTER and the MEASURED LRA grids.</td> | This is active in both the MASTER and the MEASURED LRA grids.</td> | ||
Revision as of 02:01, 28 February 2018
|
Revision 2.9.5Release Date: February 19, 2018
|
|
Contents |
ENHANCED- FASTER USER INTERFACE
|
VTube is now faster due to some important changes to the user interface. |
FIX - SOLID MODEL IMAGE PRINT IN REPORTS
|
VTube handles multiple displays. |
|
NEW - SEPARATE PERSPECTIVE MODES FOR STEP and LASER WINDOWS
|
In previous versions, there was only a single Perspective Mode switch. |
|
NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS
|
When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc. |
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
