Difference between revisions of "VTube-LASER v2.9.10"
From ATTWiki
(→25pxOTHER CHANGES) |
(→25pxNEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART) |
||
Line 40: | Line 40: | ||
<td> | <td> | ||
− | [[image:vts_v2.9.10_ScannerAcceptButton_ROMER.png|300px]] | + | [[image:vts_v2.9.10_ScannerAcceptButton_ROMER.png|300px]] |
[[image:vts_v2.9.10_ScannerAcceptButton_FARO.png|300px]]<br><br> | [[image:vts_v2.9.10_ScannerAcceptButton_FARO.png|300px]]<br><br> | ||
</td> | </td> | ||
Line 47: | Line 47: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
− | |||
==[[image:Check.jpg|25px]]NEW - HERBER Bender Corrections Through a Network== | ==[[image:Check.jpg|25px]]NEW - HERBER Bender Corrections Through a Network== |
Revision as of 11:33, 3 July 2018
Revision 2.9.10Release Date: July 1, 2018
|
Contents |
NEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART
VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.
We have redesigned the scanning engine so it no longer requires this in-range scanning position. |
NEW - HERBER Bender Corrections Through a Network
We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.
|
NEW - HERBER Bender Setup From Solid Model Through a Network
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature