Difference between revisions of "VTube-LASER v2.9.10"
(→25pxNEW - LASER SCAN FILTER SOUND) |
(→25pxNEW - LASER SCAN FILTER SOUND) |
||
| Line 26: | Line 26: | ||
==[[image:Check.jpg|25px]]NEW - LASER SCAN FILTER SOUND== | ==[[image:Check.jpg|25px]]NEW - LASER SCAN FILTER SOUND== | ||
| − | <table cellpadding=10 width= | + | <table cellpadding=10 width=1000> |
<tr valign=top> | <tr valign=top> | ||
| Line 42: | Line 42: | ||
This is a short video that shows how the Laser Scan Filter sound helps you know when all laser scan data is removed by the scan filters. | This is a short video that shows how the Laser Scan Filter sound helps you know when all laser scan data is removed by the scan filters. | ||
| − | <table width= | + | <table width=300> |
<tr> | <tr> | ||
| − | <td width= | + | <td width=200> |
</td> | </td> | ||
<td width=200> | <td width=200> | ||
Revision as of 22:05, 4 July 2018
|
Revision 2.9.10Release Date: July 1, 2018
|
|
Contents |
NEW - LASER SCAN FILTER SOUND
|
In previous versions of VTube-LASER, the scanning sound goes silent if the SCAN BUTTON is pressed and no scan data entering VTube-LASER. |
Video 86: VTube-LASER's LASER SCAN FILTER SOUNDThis is a short video that shows how the Laser Scan Filter sound helps you know when all laser scan data is removed by the scan filters.
|
NEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART
|
VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.
We have redesigned the scanning engine so it no longer requires this in-range scanning position. |
|
NEW - HERBER Bender Corrections Through a Network
|
We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.
|
|
NEW - HERBER Bender Setup From Solid Model Through a Network
|
We added the HERBER SOL file protocol that allows VTube-LASER to send NEW data to the HERBER benders through a network connection.
|
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
