Difference between revisions of "VTube-LASER v2.9.12"
(→25pxNEW - LRA POPUP MENU SPLITS ONE BEND INTO TWO FOR MORE ACCURATE MEASURING QUALIFICATION and BENDER CORRECTION) |
(→25pxNEW - LRA POPUP MENU SPLITS ONE BEND INTO TWO FOR MORE ACCURATE MEASURING QUALIFICATION and BENDER CORRECTION) |
||
| Line 30: | Line 30: | ||
<td width=300> | <td width=300> | ||
| − | This is very useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data.<br><br> | + | This "split a bend" command is very useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data.<br><br> |
After splitting a bend into two adjacent half-bends, you can use the SPLIT BEND measuring feature to measure the bend angle inside and outside to overcome this problem.<br><br> | After splitting a bend into two adjacent half-bends, you can use the SPLIT BEND measuring feature to measure the bend angle inside and outside to overcome this problem.<br><br> | ||
</td> | </td> | ||
Revision as of 00:09, 11 August 2018
|
Revision 2.9.12Release Date: August 13, 2018
|
|
Contents |
NEW - LRA POPUP MENU SPLITS ONE BEND INTO TWO FOR MORE ACCURATE MEASURING QUALIFICATION and BENDER CORRECTION
|
This "split a bend" command is very useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data. |
|
|
Follow these steps to use with Split Bend Measuring1 - Select the bend to split in an LRA grid. See VTube-LASER Split Bend Feature for details on the Split Bend measuring feature. |
|
OTHER CHANGES
|
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
