Difference between revisions of "VTube-LASER v2.9.14"
(→25pxNEW - ENTER FRACTION VALUES for FLOATING POINT in PART SETUP, XYZ GRIDS, and LRA GRIDS) |
(→25pxNEW - VTUBE IS NOW COMPATIBLE WITH THE NEW FARO 8-AXIS USB DRIVER (6.2.0.26)) |
||
| Line 72: | Line 72: | ||
<td width=300> | <td width=300> | ||
| + | [[image:usbicon_black.png|200px]]<br><br> | ||
Previous versions of VTube-LASER will not read the ball probe values with this new driver.<br><br>Version 2.9.14 was changed to work with this new FARO driver. In fact, this FARO driver is highly recommended as long as you have this version of VTube-LASER or newer.<br><br> | Previous versions of VTube-LASER will not read the ball probe values with this new driver.<br><br>Version 2.9.14 was changed to work with this new FARO driver. In fact, this FARO driver is highly recommended as long as you have this version of VTube-LASER or newer.<br><br> | ||
You can download this latest FARO driver from this [https://www.advancedtubularsupport.com/faro-arm-drivers.html support page.] | You can download this latest FARO driver from this [https://www.advancedtubularsupport.com/faro-arm-drivers.html support page.] | ||
| Line 85: | Line 86: | ||
<br><br> | <br><br> | ||
| − | |||
==[[image:Check.jpg|25px]]FIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST == | ==[[image:Check.jpg|25px]]FIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST == | ||
Revision as of 20:29, 28 August 2018
|
Revision 2.9.14Release Date: In development
|
|
Contents |
NEW - ENTER FRACTION VALUES for FLOATING POINT in PART SETUP, XYZ GRIDS, and LRA GRIDS
|
We discovered a customer that had to manually convert Imperial fractional units from a tube print. So we taught VTube how to accept fraction values in the PART SETUP, XYZ GRIDS, and LRA GRIDS. Acceptable Fraction Forms
Rule Breaker Examples
|
|
NEW - VTUBE IS NOW COMPATIBLE WITH THE NEW FARO 8-AXIS USB DRIVER (6.2.0.26)
|
|
|
FIXED - COULD NOT CLEAR ALL CUT PLANES from the CUT PLANE LIST
|
We discovered that, when you delete the entire list of Cut Planes, VTube-LASER will most likely bring at least one of them back. (They are not cleared permanently.) |
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
