Difference between revisions of "VTube OMCG Bender Correction"
From ATTWiki
(→Network Protocol) |
(→Network Protocol) |
||
| Line 18: | Line 18: | ||
__TOC__ | __TOC__ | ||
| − | = | + | =OMCG Communications Protocol= |
<table width=1000> | <table width=1000> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | We worked with OMCG to add the Supravision Network protocol to their bender control software.<br><br> | + | We worked with OMCG to add the Supravision Network protocol to their bender control software. This protocol is embedded in VTube-LASER.<br><br> |
They released version 2.02 in early 2019 with this new communications / corrections capability.<br><br> | They released version 2.02 in early 2019 with this new communications / corrections capability.<br><br> | ||
</td> | </td> | ||
Revision as of 17:49, 14 February 2019
|
This page describes the use of the VTube-LASER to OMCG bender corrections. |
Back to VTube-LASER
Contents |
OMCG Communications Protocol
|
We worked with OMCG to add the Supravision Network protocol to their bender control software. This protocol is embedded in VTube-LASER. |
|
Other Pages
- See VTube-LASER
- See VTube-STEP
