Difference between revisions of "VTube OMCG Bender Correction"
From ATTWiki
(→Settings) |
|||
Line 2: | Line 2: | ||
[[image:vtube-laser_logo_1.96.png|300px]] | [[image:vtube-laser_logo_1.96.png|300px]] | ||
[[image:OMCGSplash.png|400px]]<br><br> | [[image:OMCGSplash.png|400px]]<br><br> | ||
+ | [[image:VTube-LASER_OMCGSplash.png|700px]]<br><br> | ||
<table width=1000> | <table width=1000> |
Revision as of 22:25, 14 February 2019
This page describes the use of the VTube-LASER to OMCG bender corrections. |
Back to VTube-LASER
Contents |
OMCG Communications Protocol
We worked with OMCG to add the Supravision Network protocol to their bender control software. This protocol is embedded in VTube-LASER. |
Using the OMCG Measuring System Interface
Click on the Measuring System button in the toolbar to load the Measure System Interface. NOMINAL EXPORT
NOMINAL IMPORT
CORRECTIONS
|
Configuring the OMCG Measuring System Interface
Click on the setup button in the Measuring System Interface menu to configure the measuring center communications. Configuring the Settings
|
Other Pages
- See VTube-LASER
- See VTube-STEP