Difference between revisions of "CNC Bender v11-20090609"
| Line 40: | Line 40: | ||
# = | # = | ||
| − | When using two character operators, it is important that there are no spaces between the two characters, or preceding the first character: | + | When using two character operators, it is important that there are no spaces between the two characters, or preceding the first character. Here is an example: |
<pre> | <pre> | ||
Revision as of 01:48, 13 June 2009
Contents |
NEW - Seam Detect Mode in PreBend Dynamic Options
 |
 |
The seam detect logic was ported into the latest version of CNC Bender from the older LiteControl platform. This logic allows for seam detection logic modes including the capability of rotating the tube in the rotation spindle until the seam/scribe/etch is located.
See CNC Bender Seam Detection for details.
NEW - Pre Enable Process List
The Pre Enable Proceslist allows for setting PID values BEFORE the axes are enabled. This allows the customer to quickly change the In Position Band value of any axis before the axis is enabled.
The first application of this is to allow for quick changing of the in position band of the bend axis from 1 degree In Position Band to 0.5 or 0.25 degrees.
NEW - Added Operators to the [IF] and [IFNOT] Blocks in the Process Lists
When using the pos() command in an IF block of code, the following operators are now allowed:
- <
- >
- <=
- >=
- =
When using two character operators, it is important that there are no spaces between the two characters, or preceding the first character. Here is an example:
[IF] or, pos(1)<= 100 DO This [END]
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
