Revision 2.9.2 Build 104

Release Date: December 1, 2017

• Back to VTube-LASER
• Back to VTube-LASER Updates
• See also VTube-STEP Updates
• Download in updates the VTube-LASER Support Page

As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends.

At best, the split bend centerline would be 0.020" off from the original.

In addition to the fix, the logic has been improved to be faster and more reliable than in any previous version.

The same issues that affected the Split Bend logic also affected the Bend Profile logic.

This has been repaired in this version.

A customer discovered a rare end trim condition that we were able to reproduce and fix. The issue occurred when end trim stripes were captured both near the end and near the first or last bend. This confused the end trim logic. The logic has been completely redesigned to not only overcome this issue - but to find the end-trim even faster than before.

Our tests also showed that, with this new logic, the end-scan technique is not as important as it was in previous versions. The key is to be sure that the END WALL is the furthest point out in an end scan.

See the image on the right for an example. Using this kind of scan - with lots of points along the diameter, we were able to consistently find the end of this tube within a few thousandths every time.

• A bug was discovered for saving the Default Project file where some of values recently changed would not be stored in the default setup. This is fixed.