Difference between revisions of "VTube-LASER v2.9.12"
From ATTWiki
(→25pxFIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT) |
(→25pxFIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT) |
||
| Line 26: | Line 26: | ||
==[[image:Check.jpg|25px]]FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT == | ==[[image:Check.jpg|25px]]FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT == | ||
| − | <table cellpadding=10 width= | + | <table cellpadding=10 width=900> |
<tr valign=top> | <tr valign=top> | ||
Revision as of 04:08, 26 July 2018
|
Revision 2.9.12Release Date: Unreleased
|
|
Contents |
FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT
|
The Bender Setup window could improperly attempt to display on a monitor that was available, but is now no longer available. This has been resolved.
|
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
