VTube-LASER Training Agenda

Back to VTube-LASER

About the Training Agenda

Training agendas for VTube-LASER usually follow the pattern shown below. We often adjust the training depending on the customer's application needs.

Number of Trainees and Types of Trainees

The number of trainees in the training depends on the role each trainee is assigned. There are two types of trainees: Hands-on Trainee and Observer Trainee Hands-on Trainees: 3 maximum Hands-on trainees handle the computer and arm. n the steps we show below, many of the actions are hands-on practice. If we have 3 trainees, then the step will require 3 iterations. If we have 5 trainees, then the step will require 5 iterations. Having too many students in the hands-on training may limit how much information we can give. The fewer the number of hands-on trainees, the faster training goes. Observer Trainees: 3 maximum If you limit some of the trainees to observers, then the training will move more quickly, and we will be able to teach more information. Appropriate Equipment Large Monitors Also, it is important to know that larger monitors are necessary for training larger numbers of trainees - whether they are hands-on or observers. For example, 6 total trainees cannot easily see a laptop monitor at the same time. It is very important to have a large monitor for a class with that many trainees. (Large = 27" or larger). Amplified Sound Please be sure that have amplified sound for this system so that everyone can hear the sound feedback.

Typical Training Agenda

Day 1

LESSON	INSTALLATION / TRAINING TASK	COMMENTS
1	Arm installation and setup	Trainees can watch this process to learn how to setup the arm for use and take down the arm for storage.
2	Bender integration assistance	Trainees can watch us if they want to know the technical parts of setup. This part is best for an IT person.
3	Probe and scanner calibration	For operators
4	Setup a program from solid model	For engineers and operators
5	How to setup a program from a print	For engineers and operators
6	Arm connection and scanner setup	For operators
7	Measuring Cut Planes (measuring the table surface)	For operators
8	General measuring setup (set your default tolerances into VTube-LASER)	For operators
9	How to measure the tube/pipe	For operators
10	Understanding the inspection results to qualify the tube shape	For operators and engineers
11	Using the Bender Setup window to connect to benders for setup and correction	For operators
12	How to view reports	For operators and engineers
13	How to reverse-engineer a tube
For operators
14	Address any unique application needs	For operators
15	Hands-on practice	For operators

Day 2

STEP	INSTALLATION / TRAINING TASK
1	Review what we learned on day 1 - quiz the trainees
2	Practice full corrections loops with actual customer parts
3	Review special application needs

Other Pages

• Back to VTube-LASER