VTube-LASER v2.9.6

Revision 2.9.6 Release Date: March 13, 2018 Build: 6 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW - AB Length Tolerances in the User Interface

We added AB Length + and - tolerances to VTube-LASER.

NEW - AB Length Tolerances in the Reports

We added AB Length + and - tolerances to VTube-LASER for reports too.

NEW- SUPRAVISION STYLE OOT CHARACTER

Supravision displayed all deviations with an asterisk next to them in reports. VTube-LASER can now do the same. However, VTube-LASER allows you to configure the out-of-tolerance text to use in System Options.

NEW - GO DIRECTLY TO PRINT REPORT BUTTON

We added a new button in the report menus that let you go directly to the print dialog.

NEW - REQUEST REVERSE CALC WHEN EXITING THE LRA GRIDS

When you edit the data in the LRA grid, VTube-LASER now assumes that you probably mean to perform a reverse calc. If you exit the grid without a reverse calc, then it will immediately ask if you intended to perform a Reverse Calc - and allow you to choose to calculate the XYZ data. This is active in both the MASTER and the MEASURED LRA grids.

FIX - REPAIRED LOSS OF ORIGINAL ORIENTATION DURING REVERSE CALC

VTube always attempts to keep the original XYZ orientation when you perform a Reverse Calc from LRA to centerline XYZ data. We discovered that certain situations would cause VTube to lose the orientation during Reverse Calc. This has been fixed in this version.

FIX - BUILD TO TUBE TO SOLIDWORKS

VTube would incorrectly build a single tube to both a single part drawing and a SOLIDWORKS assembly. If VTube is building a single tube in SOLIDWORKS the best action is to always build a single part drawing. The build logic has been fixed in this version. If there are multiple parts in VTube, then VTube will still allow you to choose between building all the parts into one drawing, or building all the parts into a SOLIDWORKS assembly.

NEW - BEND-TECH 7X IMPORT

Now VTube can import the new BEND-TECH 7x format as well as the older version 6 format.

NEW - DENGLER VDS IMPORT (XYZ Data)

VTube can now import DENGLER VDS files. (DENGLER VDS files contain centerline XYZ coordinates.)

NEW - DENGLER VDS EXPORT(XYZ Data)

VTube can now export DENGLER VDS files. (DENGLER VDS files contain centerline XYZ coordinates.)

NEW - MINIMUM CLAMP LENGTH

VTube has a new Minimum Clamp Length field in the Part Setup menu. If any bender data length is shorter than the minimum clamp length, then VTube will now issue a warning in the header above the viewport.

NEW - ZERO-DEGREE BEND ANGLE WARNING

If any bend angle is less than 0.1 degrees, VTube will now issue a "Zero-degree bend" warning in the header above the viewport.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature