VTube-LASER v2.9.12

Revision 2.9.12 Release Date: August 13, 2018 Current Build: 1 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW LRA POPUP MENU SPLITS ONE BEND INTO TWO

Use this to split a very sharp angled bend into to adjacent bends in preparation for SPLIT BEND measuring. This is especially useful for when a bend angle throws an intersection point far from the tube and creates unreliable tangent deviation and bender correction data. How to use: 1 - Select the bend to split in an LRA grid. 2 - Right click. 3 - Choose "Split Selected Bend into Two Bends" 4 - In the Bend Setup tab above the XYZ data, click on Split Bend. 5 - In the Split Bend window, set the straight (which is the same as the bend #) to Split Bend at Apex. (Watch the data compress in the LRA grid when you exit the window.)

OTHER CHANGES

Fix - The End Length deviations were one iteration of the Best Fit loop behind the final value in the Tube Data Storage. This has been fixed so that the final end length values are correctly displayed in Tube Data Storage. (Other deviation data was already correctly stored.)

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature