VTube-LASER v2.9.12

Revision 2.9.12 Release Date: August 13, 2018 Current Build: 1 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW LRA POPUP MENU SPLITS ONE BEND INTO TWO

The USAF asked us to add a feature that allowed for splitting a very sharp-angled bend into two adjacent half-bends. This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data. Use this new feature with the SPLIT BEND measuring feature.
Follow these steps to use with Split Bend Measuring 1 - Select the bend to split in an LRA grid. 2 - Right click. 3 - Choose "Split Selected Bend into Two Bends" 4 - In the Bend Setup tab above the XYZ data, click on Split Bend Setup. 5 - In the Split Bend Setup window, set the STRAIGHT with the ZERO straight length to "Split Bend at Apex" (It will equal the BEND number + 1). Watch the data compress and highlight in the LRA grid when you exit the window.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature