VTube-LASER v2.9.16

Revision 2.9.16 Release Date: October 19, 2018 Current Build: 2 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW - Reverse XYZ Data and Reset Point Labels at the same time

VTube-LASER and STEP now allow for the centerline XYZ points and point labels to be reversed at the same time with a new feature in the XYZ popup menu.

FIX - IMPORTANT UPDATE for IMPORTING and MEASURING 180-DEGREE BENDS

If you import models with 180-degree bends, then you will use the Split Bend COLLECTION feature in VTube-STEP. If you measure 180-degree bends, then you will use the Split Bend MEASURE feature in VTube-LASER. Both of these features use the same Split Bend math engine. We discovered a problem that could cause the centerline of the Split Bend construction to be short by 0.020 inches (0.5 mm). If you use the Split Bend logic in VTube, then this update is critical for you because it addresses an issue we discovered during some research into Split Bend measuring issues with a customer.

NEW - SUPRAVISION BATCH IMPORT - NOW USES YOUR DEFAULT SETUP TO BUILD PROJECT FILES

The Supravision batch import can import any number of Supravision files at one time - building huge numbers of VTube project files in minutes. We added the ability for this batch engine to automatically use your current project default when importing the data.

NEW - VTUBE-STEP NOW IMPORTS AUTODESK INVENTOR TUBE XYZ FILES

Autodesk Inventor can create text files that contain the centerline XYZ data for a tube. VTube-STEP can now import these files.

OTHER CHANGES

Fix - "Reset Point Labels" - The point labels no longer revert to the previous state if you save the project after a point label reset.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature