CNC Bender
From ATTWiki
Contents |
FAQ
- What is Manual Mode?
- What is Auto Mode?
- What is Step Mode?
- What is Master Power On?
- What is the CNC Processor?
- Can Master Power Be Kept ON by CNC Bender?
- Do you support Feed Boost Benders?
- How Do I Make A Dynamic Option Invisible?
- How Do I Install CNC Bender On a New Computer?
- What is a CIO Object?
- What is the CIO Editor?
- How do I use the Post Fault Processlist?
- How do I use the Post Halt Processlist?
Tutorials
- Restoring the Configuration File in CNC Bender
- About the Constant On Button
- Ideas for SMT Bend Machine Optimization
- Ideas for CNC Bender Bend Program Optimization
Diagnostics
Diagnostic Steps for Master Power On Problems
General Information
About Top Hats (Schneider Momentum Ethernet Adapters)
Downloading Top Hat Setup Software for Top Hat setup
Downloading I2T HMI Software
Configuration
About main.axislist file
About CNCProcessor.cfg file
Version Enhancements
July 17, 2006
Version 10.0.5.9 Released - Axis Enable Delay After Cycle Start is added. This feature delays the moment of ENABLE by a millisecond value in order to give the axis drives time to boot.
May 15, 2006
- CNC Bender 10.0.5.7e - Dynamic Correction - This new feature allows for real-time correction and adjustment of the bender for each part.
- CNC Bender 10.0.5.7e - New Graphic Window - Now handles bends equal to or greater than 180 degrees
- CNC Bender 10.0.5.7e - Auto Dynamic Option Update - Easier automated update process
