Building Tube Assemblies in SOLIDWORKS
|
|
|
VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.
Applications for Calculating Tube Elongation Percentage
Application 1: For Reuse on New Parts
You could setup and bend the part and measure the cut length before and the length of elongation on the end of the tube after bending for every part. Or you could store this information in VTube's springback compensation library and use it to predict the lengths of future parts with similar materials and setups. (VTube stores the tube elongation % for a setup inside the springback table.)
Application 2: To Unbend Parts with Components in VTube
VTube can unbend tubes in real-time. Unbent parts with holes and components unbent are more useful if they take into account proper tube elongation. For example, you may need to unbend a tube with holes in order to drill the holes before bending. Accounting for elongation becomes critical in this situation.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
