Building Tube Assemblies in SOLIDWORKS

Back to VTube-STEP Back to VTube-LASER

VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.

STEP 1: Measure the Part in VTube-LASER

Without moving the assembly, measure the first pipe, then use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.

Read More About Tube Elongation

• About Multi-Elongation in VTube
• How to Calculate Tube Elongation Percentage in VTube-LASER

Other Pages

• Back to the VTube-STEP page
• Back to the VTube-LASER page