VTube-LASER Addata ZModem Communications Protocol

Addata ZModem Protocol Back to VTube-LASER Back to VTube Software Updates (for LASER Mode) Download in updates the VTube-LASER Support Page

About the Addata ZModem Communications Protocol

The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface". It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena Software bender controls.)

VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog.