VTube-LASER Training Agenda

Back to VTube-LASER

About theTraining Agenda

Training agendas for VTube-LASER usually follow the pattern shown below. Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.

Typical Training Agenda

Day 1 1 - Arm installation and setup 2 - Bender integration assistance (Note: Steps one and 2 may take a few hours) 3 - Probe and scanner calibration 4 - Step through the Quick Start Guide document 5 - Hands-on practice for students 6 - Address any unique application needs - like using the ball probe, reverse engineering, assembly, measuring square tubing, etc. Day 2 1 - Review what we learned on day 1 - quiz the students 2 - Practice full corrections loops with actual customer parts 3 - Review special application needs

Other Pages

• Back to VTube-LASER