VTube-LASER Training Agenda

Back to VTube-LASER

About theTraining Agenda

Training agendas for VTube-LASER usually follow the pattern shown below. Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.

Typical Training Agenda

Day 1 1 - Arm installation and setup 2 - Bender integration assistance (Note: Steps one and 2 may take an hour or two) 3 - Probe and scanner calibration 4 - Setup a program from solid model 5 - How to setup a program from a print 6 - Arm connection and scanner setup 7 - Measuring Cut Planes (measuring the table surface) 8 - General measuring setup (set your default tolerances into VTube-LASER) 9 - How to measuring the tube/pipe 10 - Understanding the inspection results to qualify the tube shape 11 - Using BENDER SETUP to connect to benders for setup and correction 12 - How to view reports 13 - How to reverse-engineer a tube 14 - Address any unique application needs 15 - Hands-on practice for students Day 2 1 - Review what we learned on day 1 - quiz the students 2 - Practice full corrections loops with actual customer parts 3 - Review special application needs

Other Pages

• Back to VTube-LASER