VTube-LASER v2.9.3

Revision 2.9.3 Release Date: January 10, 2017 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download in updates the VTube-LASER Support Page

NEW - Support for MicroScribe Arms from Revware

VTube-LASER now supports the MicroScribe arms with the ball probes. These arms measure smaller parts and are therefore less expensive than larger arm solutions. The arm that we tested VTube-LASER with is a MicroScribe i arm. You can view a PDF brochure here: MicroScribe i Brochure This arm has a two-foot reach (four-foot total volume) with an accuracy of +/- 0.005" (127 microns).

NEW - DENGLER Bender Corrections Support

Dengler benders are known for bending long brake and fuel lines. This new communications protocol quickly adjusts the DENGLER MES bender files directly that can then be loaded into the DENGLER controls.

NEW - Guide Windows in Bender Setup

We've put Guide Windows in the Bender Setup menu. They can stay open for as long you as you want - or close them anytime. They are less obtrusive than the dialogs that required the operator to press "OK" to continue.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature