VTube-LASER v2.9.10

Revision 2.9.10 Release Date: July 1, 2018 Current Build: 10 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW - HERBER Bender Corrections Through a Network

We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.

NEW - HERBER Bender Setup From Solid Model Through a Network

We added the HERBER SOL file protocol that allows VTube-LASER to send NEW data to the HERBER benders through a network connection. Use this new feature to import solid models into HERBER bender controls.

NEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART

VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan. For the ROMER scanner, this is one of the two side buttons. For the FARO scanner, this is the red button.) <We have redesigned the scanning engine so it no longer requires this in-range arm. As of this version, VTube-LASER removes that requirement. VTube will watch for and react to the accept button press even if no laser data is incoming.

FIX- CONSTRUCT TUBE FEATURE WORKS AGAIN

A customer discovered that the Construct Tube feature was not working in the previous version due to changes in the measuring code logic. We fixed the broken code in this version.

FIX- VTUBE-STEP MODE COLLECTION SELECTION ISSUE

(Note: VTube-STEP is included in the VTube-LASER license. It is used for importing model data.) We found issues with the collected objects in VTube-STEP mode. For example, the selected collected object (see the orange object) would never delete from the screen - even if the operator selected it and pressed delete. This issue could cause index errors in the Collection Features list memory displayed in the grid. The Collection Features Grid would not update automatically after a delete of the models on the screen. All of these issues have been fixed.

OTHER CHANGES

VTube-LASER will stop a Construct Tube process with ROMER arms if the LASER mode is active. It will also issue a warning to turn the LASER off. The laser stripe data is now displayed on the screen with lines between the points. This feature makes the stripes much easier to see on the screen.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature