CNC Bender v11-20080822
From ATTWiki
CHANGES to CNC PROCESSOR
Added Edge Trigger for Inline Conditional Logic
Edge Trigger logic is used to require a button to be released then pressed before it is considered activated. This is usually applied where it is unsafe to allow a button to be continuously pressed (without release) for machine operation.
In previous versions, conditional logic in a process list would not use Edge Trigger logic if it was enabled. Now it uses Edge Triggers when the feature is set to true for any input or output acting as an input.
An example of process list condition logic is shown here:
The [if] line shows an input CIO that is setup for Edge Trigger logic.
Previous versions of CNC Bender only use Edge Trigger logic inside COMDEFs that are inserted into process lists. (A COMDEF is a list of CIO objects).
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
