Romer

As of November of 2017, our VTube-LASER is compatible with any ROMER arm that uses a ball probe and/or laser scanner through the RDS driver. See RDS Versions for ROMER Scanners See VTUBE-iMC - Tube Measuring System with ROMER Absolute Arms See ROMER Ball Probes See ROMER Certified Length Bar

The older ROMER arms were a measuring center well-known for its Supravision software and portable measuring centers. As of the turn of the century, Romer had begun replacing Supravision with the newer DOCS software. HEXAGON purchased the ROMER brand in December, 2004.

Bender Connection using Benderlink Software

• Our Benderlink Ethernet Module allows Romers with Supravision or DOCS to connect to any VELOG, EL-2000, or Premier Eaton Leonard bender control.

See also ROMER to Eaton Leonard Bender for a diagram.

Tube Measuring Probes

Some ROMER arms use infrared probes to measure tube shapes. The probe shown here is the 25mm probe (also called the 1 inch probe)

See the source page for this image.

Calibration Probes

ROMER arms uses ball probes for calibration of the arm. The probe shown here is the 15mm steel ball probe for calibration of the arm.

Calibration Bars

This is commonly called a T-Bar. It is used to calibrate the tube measuring probes.